NBN ISO 21307:2021

This document establishes general principles regarding the procedure used in the construction and
quality assessment of butt fusion jointing of polyethylene (PE) piping system components specified
in accordance with relevant ISO standards. These components are installed in accordance with the
relevant codes of practice, national regulations or industry guidance. Specifically, this document
specifies three butt fusion jointing procedures for PE pipes and fittings. These are:
— single low-pressure fusion jointing procedure;
— dual low-pressure fusion jointing procedure;
— single high-pressure fusion jointing procedure.
This document takes into consideration the materials and components used, the fusion jointing
procedure and equipment and the quality assessment of the completed joint. It can be applied in
conjunction with appropriate national regulations and standards.
NOTE 1 The references for these procedures are given in the Bibliography.[1][2][3][4][5][6] Single low-
pressure fusion jointing procedure is derived from multiple procedures and agreed by experts, given in the
Bibliography [1][2].
NOTE 2 The three procedures detailed in this document are based on those most commonly used. It is not the
intention that one or more of these procedures be used to replace well established and verified industry based
procedures.